Moving Track Into Position - Click To Visit Photo Gallery

A Guide To Track Construction

Laying the track - known in railway terminology as the "Permanent Way" - is an operation, which requires traditional engineering skills, much physical labour and specialised equipment.

Description of the Track
The track you will see on the Waterford & Suir Valley Railway is the traditional type, which has sustained the railways of Ireland for more than a century. It has come to the company from Iarnrod Eireann who now almost exclusively use modern continuous welded rails.

The track consists of 87lb per yard rail, is know as "bull head" rail and sits in cast iron chairs, which are bolted to wooden sleepers. It was especially chosen in order to preserve and represent to future generations the technology of Victorian railway. There are approximately 118 panels of track in every mile.

Regauging the Track
The FAS crew under the supervision for Former Permanent Way Superintendent, Dan Donovan, re-gauge the track from the standard Iarnrod Eireann gauge of 5ft 3ins, down to the traditional narrow gauge of 3ft. The really heavy work begins then!

Leigh Timpson Fas, Mick Doyle And Dan Donovan - Click To Visit Photo GalleryLaying the Permanent Way
The Permanent Way of the Waterford & Suir Valley Railway is laid to the highest standards of safety and professional engineering.

A bed of limestone known as "ballast" is spread along the route of a depth of 5-6 inches. Each panel is physically aligned on top of this ballast and then bolted into position, end to end, connected by flat plates known as "fishplates".

The track panels are then cross-levelled to ensure they are flat on the straight sections, slightly higher on the left rail for right hand curves (there are no "bends" or "corners" on the railway) and on the other side for left-hand curves. These are known as "high-legs" and if not properly aligned, the trains would be unable to negotiate the curves.

When all this work has been done and levelling completed, the crew proceed to 'pack' the ballast between the rails and the sleepers, building a 'shoulder' of stone on each side and tightly pushing the ballast in between, so the ballast acts as a locking 'key' to keep the line firm and steady for the weights and speeds which will travel over it.

Waterford & Suir Valley Heritage Railway, Co. Waterford, Ireland. Phone: 051 384058
Website By: Déise Design